I had an iPhone 4 (Model A1332) that I did a screen swap on and when I tried to switch to the front camera it would freeze on the shutter. The only thing i normally leave off is the copper binding around the digitizer connector (but i tested that as well without above asked about the solution at this link: I should add, I make sure that i reinstall everything exactly the same as it was. Hope someone can help or at least test this after an install to see if they come across the same issue. I do not believe i have damged the front camera during installation, as i say, i have done quite a few by now, so what else could be causing this? What does the little spring do next to the rear camera? is the camera shield plate that sticks to the back of the digitizer really neccessary? does it creat a circuit somehow? the minute i touch the switch camera icon, top right, so that the front facing camera is in use it freezes the camera and the only way out of this is to go to settings/general/reset all settings. When i test the camera it functions normally, that is the rear camera takes pictures and video no problems, But. Hi there, I am hoping someone can help me out with an issue i have encountered about 3 times in the last 10 screen changes.Īll goes well and i reassemble the new digitizer/lcd etc and all is flush.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |